2018 BMW 330I Engine Problems

Car keeps overheating. Water pump, water hose and expansion tank have been replaced several times and the car still overheats.

My 330i 2018 bmw has a cracked in the oil housing unit. This is due to bmw putting plastic parts instead of aluminum. After researching this I found thousand of people complaining about the sane thing. The car overheats and sometimes the oil gets mixed into the coolsnt system b causes more damage. This seems to happen on cars with mileage between 60-70 on engines B46, B48 n B58z

Oil Filter Housing failed and coolant gushes all out which makes the car undrivable and risk of engine overheating and failure.

The vehicle gave a warning that the engine coolant was low and to power down before it overheated. Upon taking it to the dealer, it was discovered that the oil housing unit was defective. After doing online research, this is a very common issue with this part. I had a previous vehicle with a similar issue that caused the vehicle to shut down in traffic from overheating.

On 12/03/2024, while traveling at approximately 35mph, the "top off coolant" light came on. After traveling for approximately 10 more minutes, in route to get coolant, a warning message came on the screen advising to drive cautiously to prevent engine scorching. The vehicle then began to slightly lose power while traveling on a busy road. The vehicle was then shut down and towed to BMW dealership. During the tow, it was discovered that coolant was leaking from the center area of the engine block. The manufacturers dealership service rep advised that the technicians discovered that the oil filter housing needed to be replaced. They also found that the coolant pump also needed to be replaced. The rep advised that the coolant seal on the oil filter housing had worn down and caused the coolant leak. He also advised that the coolant pump needed to be replaced, as it was also leaking. It was later discovered because the valve that the pressure propelled, hot coolant flows through in the oil filter housing is made of plastic, it often wears down and coolant leaks out heavily. The water pump is also effected by the part manufacturing issue. In addition to receiving a $4,270.42 invoice for repairs today, we just recently purchased the $199.00 BMW Vehicle Check Service from the dealership on 9/23/2024. At that time, we were advised there were no issues with the vehicle. We have sense learned that there have been multiple recalls on various BMW models for this exact same issue. However, the VIN on my vehicle has not yet been identified for recall. Had this issue gone on for mere moments more, the engine could have caught fire, and or, a catastrophic crash could have ensued, effecting any driver on the road.

Multiple codes came on right after I had gotten my thermostat and my water pump fixed. However it ended up being that there was more leaks throughout the rest of the car. The car has currently cost me $3400 to fix and it’s still not fixed because nobody can figure out where the actual leak is coming from. The coolant is leaking and nobody can figure out where, it’s been having jerking issues since it started leaking and I read on other Bmw’s that the coolant leaks into the head gasket, causing the engine to blow

At around 65k miles multiple plastic engine coolant connectors and hoses crack and fail. 5 locations at the same time! Coolant pump leaks. I went to an independent repair shop for a second opinion and repairs for $2,400 so far. Cheaper than the BMW service department. There was a recall done 2 years ago for 1 hose I believe. The entire cooling system should be recalled. We could be stranded somewhere in a bad situation and the engine could be destroyed if overheated. Awful and bad design.

My oil filter housing failed at about 53,000 miles. While driving to work I got a low coolant warning and pulled over to see coolant dumping out of my car. The low coolant warning only comes on when the expansion tank is almost completely empty which can lead to oil and coolant mixing and overheating which will lead to premature engine damage without any early warning signs. I’ve read through forums and everyone on there has their oil filter housing fail at the same time, (around 50-60k miles). This is a huge issue in the community and BMW wants to charge almost 3,500 to replace it with their “revised part”. The housing has been revised 3 times now and so the manufacturer should replace these failed designs with the new revised ones. There’s already been a recall on the B48 engine for the plastic cooling line that leads into the head of the engine and it looks like the oil filter housing is the next biggest common failure. I tried to upload a screenshot from the service center at BMW with the quote and failure but it’s not working on my mobile.

On January 19, 2022 I was driving and then smoked filled inside my car and the outside engine was smoking and a light came on that said check coolant. BMW service took me in that day and they said my coolant broke. They removed it and replaced it. They did not understand how the coolant broke but I paid for the service and parts and moved forward. On November 25, 2022 I went into the same BMW service center to get a routine car service and they stated there was a recall and they would replace my coolant for free. (After I told them I paid for it ($699.63) . They insisted I replace it for free again and reach out to BMW corporate for a reimbursement of previous service. I received a call yesterday stating they would not replace it and reach out and file a report with NHTA.

ON THE WAY HOME FROM PURCHASING THIS VEHICLE AS A CPO AT THE BMW DEALER, A LOUD ENGINE KNOCK DEVELOPED. MADE AN APPOINTMENT AT THE BMW DEALER TO CHECK IT, AND ON THE WAY THERE, IT LOST POWER & ENGINE MALFUNCTION WARNING LIGHTS ILLUMINATED. HAD TO PULL OFF HIGHWAY, FEARING CAR WOULD STOP RUNNING ALTOGETHER. DIAGNOSIS WAS FAILED ROD BEARINGS, WITH LOTS OF METAL SHAVINGS IN THE OIL FILTER. MILEAGE WAS 36,500 MILES.

Mileage: 36,500