2016 BMW 428I Electrical System Problems
24 complaints about Electrical System
This Problem Across All Years
All Electrical System Complaints (24)
1. Radio cut on and off and then Engine failed. I started smelling weird fumes when I was driving but eventually the car restarted back up. 2. Car stopped on the highway and could have resulted in other vehicles running into me. 3. No, I parked the car at my house and don't drive it. 4.No, I parked the car at my house and I don't drive it 5. Yes, the yellow lights on the dash board came on and it said something about the ignition.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure.
The contact owns a 2016 BMW 428I. The contact stated that upon further inspection, the vehicle had an abnormal engine coolant leak. No warning light was illuminated. The contact stated that the engine temperature gauge was rising abnormally. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 115,000.
Mileage: 115,000
The contact owns a 2016 BMW 428I. The contact stated while driving 20 MPH, the vehicle hesitated, and the contact noticed smoke coming from the engine compartment. The check engine warning light was illuminated. An independent mechanic was contacted. The vehicle was taken to an independent mechanic and was diagnosed and determined that the engine was overheating, and the air condition system had failed. The vehicle was not repaired. The manufacturer was notified of the failure but offered no assistance. The contact related the failure to NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The contact stated that the manufacturer had exceeded a reasonable amount of time to repair the recall. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was unknown.
The engine coolant pump on my 2016 BMW 4 Series has an open recall (#24V-608), issued in August 2024. It’s been almost a year, and the remedy is still marked as "Not Available." Recently, my check engine light came on. I used my personal OBD-II scanner and retrieved fault code U019F, which indicates “Lost Communication with Engine Coolant Pump Control Module.” This is directly related to the recalled component. I contacted BMW of Bay Ridge in Brooklyn, NY, and they told me I need to pay $335 for a diagnostic, even though I already provided the fault code and it matches the recall issue. They said this is a “standard diagnostic fee,” and they do not offer reimbursement even if it turns out to be related to the recall. BMW North America customer support told me that if a dealership confirms the fault is recall-related, they may try to expedite the remedy. But to get that confirmation, I’m expected to pay out of pocket first — which I find unacceptable since the part is already under an open recall and has now failed. So far, no dealer or service center has inspected the vehicle officially because I don’t want to pay $335 to confirm something I already know. Yes, my safety is at risk — the engine cooling system is compromised, and I’m afraid to drive the car. I feel severely impacted and stuck in a situation where BMW won’t take responsibility unless I pay first. This is unreasonable. I believe BMW should cover diagnostics or offer another way to confirm the issue without forcing owners to pay out of pocket for their known safety defect. I’m requesting NHTSA’s help in resolving this issue.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System) however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that several dealers were contacted, and the contact was informed that parts were no longer available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available .
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The manufacturer has not remedied recall number 24V-608 Water Pump Electrical Connector in a reasonable time. I have contacted my BMW local service provider and they say the manufacturer has nor supplied the necessary parts with no commitment n when parts will be available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical system); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
I hear weird sounds in the car and it smells like it's burning. The car stalls while driving and while in traffic.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428i. The contact received notification of NHTSA Campaign Number: 24V608000(Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated that the vehicle intermittently failed to start immediately and required several attempts to be started. The contact stated that there was white smoke coming from the rear of the vehicle while idling or while driving at various speeds. The check engine warning light and tire pressure monitoring warning light was illuminated. The dealer was contacted. The manufacturer was not made aware of the issue. The failure mileage was unknown. VIN tool confirms parts not available.
Recall has not been remedied.
The contact owns a 2016 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.
The contact owns a 2016 BMW 428i. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. The VIN was not available.
unknown
Re BMW 2016 428ix- BMW admits that there is a design flaw in this model, but has not remedied a fix for this 'MALFUNCTION DEFECT'. Top does not open or close is the end result. Getting caught in a flash rain, and wanting to close the top was impossible. Trying to pull over to the nearest overpass till rain lightens up, the most dangerous situation to be in. This is a SAFETY issue and bmw will not take care of it. I have come to learn, that It seems in their design flaw, rain collects that you cant see, but shorts out the motor of the top and top will not function at all. Many owners have the same problem and BMW will not recall it. Local dealer says he has to drill 2 holes on the bottom of the car so water will drain out and then a new motor for the top installed. Cost $2400. BMW service knows the problem, has many cars with the same problem.There is no warning that your top wont work. DRILL 2 HOLES???
THE DOOR LOCK ACTUATOR-DRIVER'S SIDE PERIODICALLY STICKS IN A LOCKED POSITION. WHEN I ATTEMPT TO EXIT THE CAR,THE LOCKING MECHANISM DOES NOT RELEASE WHEN DOOR HANDLE IS PULLED.I HAVE TO PRESS UNLOCK BUTTON TO DEACTIVATE THE LOCK AND HAVE HANDLE RETURN TO NORMAL FUNCTION.I BELIEVE THIS IS A SAFETY ISSUE THAT NEEDS TO BE REMEDIED BY BMW
Mileage: 33,000