2000 CHEVROLET CORVETTE Service Brakes, Hydraulic Problems

S10 APPROPRIATE HANDLING- LETTER TO THE SECRETARY FROM CONSTITUENT RE COPY OF A LETTER TO GENERAL MOTORS CHIEF EXECUTIVE OFFICE MARY BARRA REGARDING A SAFETY ISSUE WITH A CHEVROLET CORVETTE. *SMD THE CONSUMER STATED THE ABS MODULE FAILED. THE ONLY WAY TO DEAL WITH THE PROBLEM, WAS TO FIND A USED ONE FOR AS MUCH AS 1,500 TO $2,000 BECAUSE THE PART WAS NOT AVAILABLE. NO ONE CAN REPAIR THE MODULE, BECAUSE IT WAS FILLED WITH RESIN. *JB

AT NORMAL HWY. SPEED (65 - 70 ) I AM LOOSING THE SAFETY OF MY ABS AND TRACTION CONTROL. THIS IS DUE TO MANUFACTURES FAULT IN THE EBCM (ELECTRONIC BRAKE CONTROL MODULE ). THIS COULD LEAD TO AN HANDLING ISSUE! *TR

Mileage: 20,000

I OWN, AS DO 75 OTHER CUSTOMERS OF TONY'S CORVETTE SHOP IN MARYLAND, A 2000 C-5 CORVETTE. ( CURRENTLY 32,000 MILES)THE ABS/TRACTION CONTROL MODULE FOR THIS VEHICLE HAS BEEN DISCONTINUED BY GM. MY MODULE AS WELL AS THE OTHER OWNERS HAS FAILED AND IS NO LONGER AVAILABLE FOR REPLACEMENT. FURTHER OPERATION OF THESE VEHICLES INVITES SAFETY RELATED RAMIFICATIONS AS THEY WILL NOT PERFORM AS DESIGNED FOR SAFE OPERATION. THE SHOP OWNER SEARCHED ACROSS THE NATION AND THERE ARE NO REPLACEMENTS AVAILABLE. WHY HAS GM FAILED TO MEET THE SAFETY NEEDS OF THE PUBLIC FOR ITS VEHICLES? *TR

Mileage: 32,000

ANTI LOCK BRAKES NO LONGER OPERABLE ON 2000 CHEVROLET CORVETTE. GENERAL MOTORS AWARE OF MULTIPLE OCCURRENCES BUT NO LONGER MANUFACTURES THE REPLACEMENT PART () ECBM AND WILL NOT ACCEPT ANY RESPONSIBILITY FOR REMEDY. *TR

Mileage: 58,000

I AM WRITING THIS COMPLAINT ABOUT A KNOWN FAULTY COMPONENT WITHIN THE C5 CHEVROLET CORVETTES. THIS PART, THE EBCM, CAUSES THE LOSS OF ABS AND TCS. THIS FAILURE IS A KNOWN PROBLEM AND HAS HAPPENED TO MANY C5 CORVETTE OWNERS. IN FACT, GM EVEN HAS A POLICY KNOWN AS HE GOODWILL POLICY IN WHICH THEY WILL RANDOMLY OFFER DISCOUNTS TO CORVETTE OWNERS. SOME WILL RECEIVE THE DISCOUNT AND OTHERS WILL NOT. WHEN WE HAD THE CAR DIAGNOSED AT A CHEVROLET DEALERSHIP AS DIRECTED BY GM OFFICIALS WE WERE TOLD THAT THEY WOULDN'T REPLACE THE PART DUE TO THE NUMBER OF MILES ON THE CAR. THIS PROBLEM HAD ORIGINALLY OCCURRED WHEN THE CAR HAD AROUND 30,000 MILES ON IT, APPEARING TO BE AN INTERMITTENT PROBLEM, AND THEN AFTER MONTHS OF DRIVING THE FAULTS WOULD NOT RESET. THE INDIVIDUALS AT GM SAID THAT THEY KNEW THERE WAS A PROBLEM, BUT THEY WOULD REPLACE THE PART ON CASE BY CASE BASIS. THE INDIVIDUAL AT GM CLAIMED THAT HE CONTACTED THE TECHNICIAN AT JAMES WOODS AND WAS TOLD THAT THE PART FAILURE WAS NORMAL, AND THAT THE PART FAILED AT AROUND 60,000 MILES. THERE WERE MANY FAILURES WITH LESS MILES THAN THAT. MY PROBLEM WASN'T THE FACT THAT THEY WOULDN'T OFFER ANY DISCOUNT, BUT THE FACT THAT THERE WAS A KNOWN PROBLEM THAT AFFECTED THE SAFETY OF DRIVERS, AND THEY WILL NOT ACT TO CORRECT THE PROBLEM. . I AM A FREQUENT POSTER ON THE FOLLOWING WEBSITE AND YOU COULD VERIFY THAT THERE WA S INDEED A KNOWN PROBLEM WITH THE EBCM. THE WEBSITE WAS CORVETTEFORUM.COM. IF YOU PERFORM D A SEARCH ON THE WEBSITE UNDER THE C5 SECTION YOU WILL SEE THAT THERE WERE MANY CASES OF INDIVIDUALS WHO HAVE EXPERIENCED THIS PROBLEM. I COULD NOT GIVE AN ACCURATE ACCOUNT OF ANY ACCIDENTS OR DEATHS DUE TO THIS PROBLEM, BUT I DO KNOW THAT THE IMPACT WAS EXTREMELY HIGH OR THAT THE POSSIBILITY OF AN ACCIDENT DUE TO ABSENCE OF ABS WAS EXTREMELY HIGH. *AK

Mileage: 30,000

HAVE FAILURE OF ABS SYSTEM ON 2000 CORVETTE. APPEARS TO BE RELATED TO FAILURE OF THE EBCM. NOT REPAIRED AT THIS TIME DUE TO $1800.00 PLUS COST. CURRENTLY THE CARS ABS AND TRACTION CONTROL SYSTEM HAS BEEN DISABLED BY THE CARS COMPUTER. *TR

Mileage: 141,800

HAVE FAILURE OF ABS SYSTEM ON 2000 CORVETTE. APPEARS TO BE RELATED TO FAILURE OF THE EBCM. NOT REPAIRED AT THIS TIME DUE TO $1800.00 PLUS COST. CURRENTLY THE CARS ABS AND TRACTION CONTROL SYSTEM HAS BEEN DISABLED BY THE CARS COMPUTER. *TR

Mileage: 141,800

VEHICLE WITH FAILURE - MY 2000 CHEVROLET CORVETTE 2D HARDTOP 6MT MILEAGE - 35,972 (AFTER ACCIDENT) (1) PANIC STOP IN CENTER LANE OF CONGESTED TRAFFIC. DRIVER APPLIES BRAKES WITH MAXIMUM EFFORT AND CLUTCH IS DISENGAGED. IMPACT WITH THE REAR OF THE VEHICLE AHEAD WAS AVOIDABLE GIVEN THE INITIAL VELOCITY AND DISTANCE FOR SEPARATION. (2) DRIVER FEELS A NOTICEABLE "POP" THROUGH THE BRAKE PEDAL AND WITH MAXIMUM EFFORT APPLIED, THE PEDAL DROPS QUICKLY TO THE VEHICLE FLOOR. THE BRAKE SYSTEM UP TO THIS POINT HAD DECREASED VEHICLE SPEED TO AT MOST 10 MPH. DRIVER MAINTAINS PEDAL EFFORT BUT THE REMAINING MOMENTUM CAUSES AN IMPACT WITH THE VEHICLE AHEAD DUE TO THE NEARLY 100% LOSS OF BRAKE PERFORMANCE. POST-IMPACT DRIVING AND INSPECTION LEADS TO THE DISCOVERY OFA RUPTURED FLEXIBLE BRAIDED HOSE, 1 OF 2 HOSES ROUTED ALONG THE DRIVER-SIDE FRAME RAIL, ADJACENT TO THE FRONT DRIVER-SIDE OF THE ENGINE. THESE TWO HOSES CONNECT THE STEEL TUBING FROM THE MASTER CYLINDER TO THE ABS CONTROLLER AND ARE PERMANENTLY ATTACHED TO THE STEEL TUBING. (3) THE COMPLETE BRAKE TUBING AND HOSE ASSEMBLY (WITH THE RUPTURED HOSE) FROM MASTER CYLINDER TO ABS CONTROLLER WAS REPLACED WITH A NEW ASSEMBLY BY THE DEALERSHIP SERVICE DEPARTMENT. THE FAILED COMPONENT, DESPITE THE VEHICLE OWNER REQUESTING OTHERWISE, WAS NOT KEPT FOR FURTHER INSPECTION. DIGITAL PICTURES AND VIDEO ARE AVAILABLE FROM IMMEDIATELY AFTER THE ACCIDENT. THE DEALERSHIP SERVICE DEPARTMENT DIAGNOSED THE CAUSE OF THE RUPTURE AS ABRASION BETWEEN FRAME RAIL AND HOSE. *JB

Mileage: 35,972

BRAKE PEDAL "STICKS" OFTEN WHEN APPLIED CAUSING UNINTENDED DECELERATION, ACTIVATION OF ACTIVE HANDLING SYSTEM, PREMATURE BRAKE WEAR, ROTOR WARPAGE, AND BRAKE FADE.

BRAKE PEDAL "STICKS" OFTEN WHEN APPLIED CAUSING UNINTENDED DECELERATION, ACTIVATION OF ACTIVE HANDLING SYSTEM, PREMATURE BRAKE WEAR, ROTOR WARPAGE, AND BRAKE FADE.

BRAKE PEDAL "STICKS" OFTEN WHEN APPLIED CAUSING UNINTENDED DECELERATION, ACTIVATION OF ACTIVE HANDLING SYSTEM, PREMATURE BRAKE WEAR, ROTOR WARPAGE, AND BRAKE FADE.

BRAKE PEDAL "STICKS" OFTEN WHEN APPLIED CAUSING UNINTENDED DECELERATION, ACTIVATION OF ACTIVE HANDLING SYSTEM, PREMATURE BRAKE WEAR, ROTOR WARPAGE, AND BRAKE FADE.

THEIR IS NO RUBBER ON CLUTCH & BRAKE PEDALS, FOOT CAN SLIP OFF WHEN WET OR WITH LEATHER SOLES. *ET

BRAKES WERE DRAGGING TO THE POINT OF LOCKING UP, AND ROTORS GOT REAL HOT. PULLED OVER, AND DISENGAGED ACTIVE HANDLING OF VEHICLE. DEALER WILL ORDER ALL NEW PARTS & RUN TESTS TO FIND OUT THE CAUSE OF THE PROBLEM. *AK

BRAKES WERE DRAGGING TO THE POINT OF LOCKING UP, AND ROTORS GOT REAL HOT. PULLED OVER, AND DISENGAGED ACTIVE HANDLING OF VEHICLE. DEALER WILL ORDER ALL NEW PARTS & RUN TESTS TO FIND OUT THE CAUSE OF THE PROBLEM. *AK

TIRE PRESSURE GAUGE ALWAYS LOW, WOULD NOT SHOW IF TIRES TOO LOW OR OVER INFLATED UNTIL TOO LATE AT ANY SPEED. ABS/ACTIVE HANDLING SYSTEM LIGHT ON, TURNED ENGINE OFF 1 MILE LATER LIGHT GOES OFF. CLUTCH PEDAL TOO STIFF.

VEHICLES BRAKES LOCKED UP, CAUSING SEVERE FLAT SPOT ON TIRES. THIS SHOULD BE A SAFETY CONCERN, AS THE CAR IS NEARLY UNCONTROLLABLE AT THE TIME OF LOCKUP. THIS VEHICLE WAS DRIVEN FROM THE MANUFACTURERS PLANT IN BOWLING GREEN, KY TO LYMAN, SC, APPROXIMATELY 400 MILES, BY WAY OF NASHVILLE, TN. IT SAT IN THE GARAGE THE FOLLOWING WEEK. THE NEXT WEEKEND, THE BRAKES LOCKED UP. TAKEN TO THE CHEVROLET DEALERSHIP THE FOLLOWING MONDAY, IT REMAINED THERE FOR TWO FULL WEEKS WHILE THEY REPAIRED THE ABS SYSTEM. WHILE AT THE DEALERSHIP, THE SYSTEM AGAIN FAILED AFTER THE FIRST ATTEMPTS TO REPAIR WERE UNSUCCESSFULL. THE SECOND ATTEMPT REQUIRED PARTS THAT WERE TO BE BACK ORDERED. THE PARTS WERE LOCATED AT THE CORVETTE PLANT, HOWEVER, AND THE REPAIRS MADE. THE VEHICLES BRAKE SYSTEM NOW APPEARS TO BE NORMAL. THE LAST PART OF THE BRAKE SYSTEM, THE TIRES, HAVE NOT BEEN REPAIRED AT THIS TIME. ONLY A "GOOD WILL OFFER" OF $75 HAS BEEN OFFERED, TOWARDS THE COST OF $1600 WORTH OF TIRES, ON A $46,000 CAR. *AK