1998 DODGE RAM 2500 Suspension Problems

I HAVE A 98 RAM 2500 V10 IF I GO ABOUT 65 MPH THERE IS A MASSIVE WOBBLE IN THE STEERING WHEEL BUT IF I SPEED UP TO 70 IT STOPS OR IF I SLOW DOWN TO 60 IT STOPS. THERE SHOULD BE A RECALL ON THIS BECAUSE ALL OF THE RAM TRUCKS THAT I HAVE HAD DO THIS EXACT SAME THING.

Mileage: 415,985

THE PASSENGER SIDE LOWER REAR ARM SUPPORT BRACKET WELD ARE CRACKING TWISTING TEARING FROM MAIN FRAME RAIL. THE FRAME WELD IS TEARING HORIZONTALLY AND ACROSS SAME RATES. THE CRACK ARE NEXT TO WELDS AN SOME LOCATION TEARING CIRCLING ROTATING. THE VEHICLE NEVER OPERATED OFF-ROAD AND MILEAGE IS 171,550 MILES. THE CRACK ARE 65% AND VEHICLE UNFIT TO BE OPERATED SAFETY. I WAS VERY FORTUNATE I DIDN'T HAVE A ACCIDENT. THE VEHICLE WOULD HAVE ROW OVER ON I LEFT SIDE WITHOUT NO WARNING . I WAS PREFORMING VEHICLE BRAKE INSPECTIONS AND I NOTICE RUST ON THE LOWER REAR SUPPORT HANGER WHICH HOLD THE LOWER ARM BRACKET AND COIL SPRING. I AM VERY FORTUNATE THAT I DIDN'T LOAN MY VEHICLE TO MY RELATIVES. I HAVE PICTURES AVAILABLE. I WANT THE CHRYSLER CORPORATION TO REPAIR THIS ASAP!!!

Mileage: 171,550

I OWN A 1998 DODGE RAM 2500, I HAVE NOTICED THIS PROBLEM ON MULTIPLE DODGES AND READ ABOUT IT ON THE INTERNET, THE FRONT LOWER AXLE MOUNT ROTS OUT DUE TO POOR DESIGN LEAVING NOTHING TO HOLD THE SPRING IN PLACE MY COIL MOUNT IS ROTTED OUT AND THERE IS BARELY ANY LEFT OF IT, AND DODGE NOR DO ANY AUTO PART STORES SELL COIL MOUNTS TO REPLACE IT THE MOUNT IS WELDED DIRECTLY ON THE AXLE SO THE AXLE HOUSING WOULD NEED TO BE REPLACED, THIS IS VERY UNSAFE IF THE AXLE WERE TO GIVE OUT DEW TO THIS. *TR

WHILE TURNING LEFT AT ANY SPEED HAVE A SERIOUS SHUDDER. TRUCK HAS NEW WHEEL BEARINGS TIE ROD ENDS ROTORS AND CALIPERS DONE AT DODGE DEALERSHIP. THE SHUDDER IS HEARD AND FELT IN FLOOR BOARD NOTHING IN BRAKE PEDAL OR STEERING WHEEL. SHUDDER IS LESS AUDIBLE WHEN PUT INTO NEUTRAL AND COASTING WHILE TURNING LEFT. *TR

Mileage: 146,000

1998 DODGE 2500 TRUCK SHAKES VIOLENTLY AFTER HITTING SMALL BUMPS. THIS PROBLEM OCCURS VERY OFTEN AT LEAST THREE TIMES A MONTH. TRACK BAR, BALL JOINTS AND SWAY BAR WERE REPLACED BUT IT MADE NO DIFFERENCE. *TR

Mileage: 118,232

MY DODGE 2500 STARTED SHAKING VERY VIOLENTLY 2 MONTHS AFTER I PURCHASED IT, IM AFRAID THAT ONE DAY I WILL KILL SOMEBODY BECAUSE IT PULLS YOU INTO THE NEXT LANE, THE DEALERSHIP SAID THREES NOTHING WRONG PLEASE HELP. *TR

Mileage: 130,000

I HAD JUST STOPPED AT A RED LIGHT AND MY STEERING WAS ACTING FUNNY - SORT OF JERKING TO THE LEFT SLIGHTLY. AS I LEFT THE INTERSECTION AND GOT UP TO ABOUT 20-25 MPH, THE TRUCK SUDDENLY JERKED HARD TO THE LEFT AND I COULD NOT RECOVER CONTROL. I CROSSED TWO LANES OF ONCOMING TRAFFIC AND FORTUNATELY DID NOT HIT ANYONE - I ENDED UP IN A SNOW BERM ACROSS THE STREET. I HAD THOUGHT IT MIGHT BE MY BRAKES STICKING BECAUSE OF THE COLD WEATHER IN ALASKA. IT TURNS OUT IT WAS A FAILURE OF THE WHEEL BEARINGS. ACCORDING TO THE MECHANIC, THIS IS A COMMON PROBLEM WITH SEALED WHEEL BEARINGS - THE SEAL GOES BAD, THE BEARINGS DRY OUT, THEN THEY LOCK UP. IT TYPICALLY RESULTS IN A TIRE FALLING OFF AND AN ENSUING ACCIDENT - OFTEN FATAL. MY 5 YEAR OLD SON WAS WITH ME AND I WAS FORTUNATE NOT TO HAVE TAKEN THE HIGHWAY WHERE I WOULD HAVE BEEN TRAVELING AT 65 MPH. I'M QUITE CERTAIN I WOULD HAVE KILLED SOMEONE IF NOT MY SON AND MYSELF. I HAVE A 1998 DODGE 2500 WITH THE CUMMINS DIESEL AND IT HAS 99985 MILES ON IT - THE DIESEL ENGINE EXACERBATES THIS PROBLEM DUE TO THE NOISE LEVEL - I MAY HAVE BEEN ABLE TO HEAR THESE BEARINGS GOING OUT SOONER. I HAD TO REPLACE THE WHEEL BEARINGS AND OTHER MISC PARTS THAT WERE TORN APART - EITHER WHEN THE BEARINGS WENT OUT OR I HIT THE SNOW BERM. *TR

Mileage: 99,895

THE CONSUMER PURCHASED THE VEHICLE ALREADY INSPECTED BY THE DEALER. A FEW DAYS LATER THE CONSUMER TOOK THE VEHICLE TO A LOCAL MEINEKE BECAUSE OF A SQUEAKING NOISE. THE VEHICLE WAS CHECKED AND THE CONSUMER WAS TOLD THAT THE VEHICLE SHOULD HAVE NEVER PASSED INSPECTION DUE TO NUMEROUS PROBLEMS FOUND WITH THE VEHICLE. *TS THE MEINEKE TECH STATED THAT EH VEHICLE SHOULD NOT HAVE PASSED INSPECT DUE TO NUMEROUS VIOLATIONS. THE VEHICLE NEEDS 2 WHEEL BEARINGS, TRACK BAR, STEERING SHOCK, 2 HUB ASSEMBLIES, BRAKE LINES, OXYGEN SENSOR AND A NEW LICENSE PLATE BULB. THE CONSUMER CONTACTED THE DEALER TO GET HIS MONEY BACK BUT THEY REFUSED. *NM

CONSUMER STATED THAT TRACK BAR IS LOOSE. DEALER NOTIFIED. *AK

CONSUMER STATES WHEN BRAKING THE VEHICLE PULLS VIOLENTLY TO THE RIGHT. PLEASE PROVIDE ANY ADDITIONAL INFORMATION. TS

AT 45MPH THE VEHICLE WILL VIBRATE HEAVILY. CAUSE UNKNOWN. DEALER NOTIFIED. COMPONENT:SUSPENSION. *AK

THIS VEHICLE HAS A DANA 70 REAR END. MANUFACTURER FAILED TO SHIM WHEN ORIGINALLY BUILT. THIS CAUSED REAR END TO SHIFT AND ELONGATE MOUNTING SECTION THUS DESTROYING ENTIRE REAR END. MANUFACTURER CLAIMS NO LIABILITY DUE TO PASSING 100,000 MILE LIMIT OF WARRANTY. MY CONCERN IS THAT ANYONE PULLING HEAVY TRAILERS COULD EXPERIENCE A TOTAL FAILURE OF THE REAR END WHILE MOVING. THIS WOULD ALMOST CERTAINLY CAUSE THE TRAILER TO JACKNIFE AND COULD LEAD TO INJURY OR AT LEAST CONSIDERABLE DAMAGE. WE HAUL SHOW HORSES THAT ARE VALUED IN EXCESS OF $150,000 AND WE JUST WANTED TO ALERT THE NHTSA AND THE GENERAL PUBLIC IN WHAT WE SEE IS A POTENTIALLY DANGEROUS PROBLEM. PERHAPS OURS IS THE ONLY OCCURANCE OR PERHAPS THERE ARE OTHERS WAITING TO HAPPEN.*AK

EXCESSIVE LOSS OF ENGINE COOLANT, BUT NO SIGN OF LEAKAGES. VEHICLE BEEN IN / OUT OF DEALER SHOP ON FOUR OCCASIONS, AND STILL UNABLE TO LOCATE PROBLEM. *AK THE CONSUMER INDICATED THAT THE MANUFACTURER INTERNTIONALLY WITH HELD THE POSSIBLE PROBLEM WITH V-10 ENGINE TO AVOID RECALL. ACCORCING TO THE INFORMATION OBTAINED FROM INTERNET, THE MANUFACTURER HAD INDICATED THAT THE V-10 HEADS AND CRANKSHAFT COULD EXPERIENCE HAIR LINE CRACKS CAUSING INTERNAL COOLANT LEAKAGE. SPARK PLUGS FAILED. FRONT BRAKE PADS FAIED. LEFT LOWER BALL JOINT FAILED. *YH

THREE BEARINGS IN THE REAR WENT OUT. *SLC

FRONT END SUSPENSION FAULTY CAUSING PULLING AND DIRECTIONAL CONTROL PROBLEMS CONTINUALLY. MJS

FRONT END SUSPENSION FAULTY CAUSING PULLING AND DIRECTIONAL CONTROL PROBLEMS CONTINUALLY. MJS

FRONT ALIGNMENT HAS A PROBLEM. YH

MY TRUCK BRAKES PULL SEVERELY TO THE RIGHT WHEN BRAKING. THIS PROBLEM EXISTS IN ALL RAM 2500 4X4 TRUCKS I HAVE ENCOUNTERED. THE DEALER HAS REPLACED ROTORS; CALIPERS;ALIGNMENT; ETC. I HAVE HAD THE TRUCK IN 9 TIMES (I HAVE DOCUMENTATION) ON THE SAME PROBLEM WITH NO RELIEF. DEALER NOW REFUSES TO LOOK FURTHER INTO THIS PROBLEM. BRAKES PULL TO RIGHT HARD ENOUGH TO SLIDE TRUCK SIDEWAYS ON WET PAVEMENT. BRAKE PADS WEAR OUT FASTER ON RIGHT FRONT - THERE HAS BEEN EVIDENCE OF THE RIGHT ROTOR GETTING HOT (BRAKES DRAGGING). THIS IS A SERIOUS SAFETY ISSUE IN A LARGE TALL AND HEAVY TRUCK! ALL DODGE RAM 2500 4X4 OWNERS I HAVE TALKED TO REPORT PERIODIC OR CONTINUOUS SIMILAR PROBLEMS WITH THEIR BRAKES. *AK

SWAY BAR BOLTS THAT HOLD SWAY BAR FELL OUT, AND ALMOST CAUSED AN ACCIDENT. WENT TO DEALER AND GOT IT FIXED. BUT THEN ALL FOUR BOLTS THAT HOLD THE SWAY BAR FELL OUT AGAIN, CAUSING AN ACCIDENT. ALSO, WORN GEAR IN THE STEERING BOX CAUSED A LOSS OF STEERING. DEALER CANNOT DETERMINE THE PROBLEM. PROBLEM STILL EXISTS. *AK *ML

CONSUMER COMPLAINTNG WHILE DRIVING VEHICLE THE BACK END GO OUT OF CONTROL WHENEVER THE VEHICLE GO OVER A BUMPS OR POT HOLE. VEHICLE BEEN IN/OUT OF DEALER SHOP MORE THEN TWICE,CONDITION STILL OCCUR. DEALER CAN FIND OR LOCATE THE PROBLEMS.