1997 FORD F-250 Engine And Engine Cooling Problems

FORD MOTOR CO. REFUSES TO DO SAFETY RECALL 07S57 ON MY 97 F-250 THE RECALL IS FOR THE CAM SHAFT POSITION SENSOR. IT MUST BE REPLACED BECAUSE THE VEHICLE STALLS WHILE DRIVING WHICH CAN LEAD TO AN ACCIDENT. THEY ARE REFUSING TO DO THE RECALL DUE TO A SEIZED BOLT. IF THIS BOLT BREAKS THEY WANT ME TO PAY $2500 TO GET THE SAFETY RECALL COMPLETED. *TR

Mileage: 165,995

I HAVE A 1997 FORD F-250 WITH WITH 87,000 MILES ON A 5.4 LITER ENGINE. ONE OF THE SPARK PLUGS WAS EJECTED FROM THE ENGINE, THREADS AND ALL, WHICH ALSO DAMAGED THE IGNITION COIL. *TR

Mileage: 86,951

MY COMPLAINT HAS TO DUE WITH THE PCV VALVE HOSE THAT RUNS TO THE VACUUM SYSTEM. IT GETS TOO WARM AND MELTS AND IT CAUSES THE ENGINE TO STUTTER OR STALL CAUSING THE VEHICLE TO STOP RAPIDLY. I HAVE NOTICED THIS ON MANY OF THE F250 OR F150 5.4L TRITON ENGINES. THIS HAS HAPPENED SEVERAL TIMES TO MY TRUCK AND IT IS EXPENSIVE TO KEEP REPLACING IT. IT HAS ALMOST CAUSED A FEW REAR ENDINGS. *TR

Mileage: 75,453

TL*- THE CONTACT OWNS A 1997 FORD F250. HE RECEIVED A RECALL NOTICE FOR THE CRANKSHAFT POSITION SENSOR. HE TOOK THE VEHICLE TO THE DEALER AND THEY RAN A DIAGNOSTIC THAT SHOWED A PROBLEM WITH 3 SENSORS. THE CONTACT IS A MECHANIC SO HE REMEDIED THE RECALL HIMSELF. WHEN HE CONTACTED THE MANUFACTURER FOR REIMBURSEMENT OF THE PARTS AND LABOR HE WAS ADVISED THAT THEY WOULD ONLY REIMBURSE HIM FOR THE CRANKSHAFT POSITION SENSOR AND THAT THEY WOULD NOT REIMBURSE HIM FOR THE OTHER PARTS OR LABOR. THE CURRENT MILEAGE WAS 86000 AND THE FAILURE MILEAGE WAS 83000.

Mileage: 83,000

MONDAY, JULY 31 2007, I EXPERIENCED THE LAST OF A SERIES OF INTERMITTENT STALLING EVENTS IN MY 1997 FORD F250 HD VEHICLE, EQUIPPED WITH A 7.3 DIT POWERSTROKE DIESEL. SUBSEQUENT TO MY OWN INVESTIGATIONS, I DISCOVERED THAT THE CAM POSITION SENSOR WAS A COMPONENT IMPLICATED IN SUCH EVENTS. I REPLACED THE COMPONENT ON JULY 27, 2007, AFTER AN INCREASE IN STALLING PROBLEMS. THE CONDITION REPEATED ON THE LATER DATE ABOVE, AND I DROVE THE VEHICLE TO A REPAIR FACILITY. THEY COULD NOT FIND ANY DIAGNOSTIC CODES FROM THE PCM, BUT THE STALLING EPISODES INCREASED DURING THEIR ANALYSIS. AFTER PERFORMING OTHER SYSTEM DIAGNOSTIC PROCEDURES, THEY WERE LEFT WITH THE FINAL CONCLUSION THAT THE CPS MUST BE THE CULPRIT FOR THE STALLING CONDITION. THE NEWER CPS I INSTALLED WAS REPLACED BY THE REPAIR TECHNICIAN WITH ANOTHER CPS. TO DATE THE CONDITION APPEARS RESOLVED. I HAVE RETAINED ALL PARTS AND THE REPAIR WORK-ORDER. *TR

Mileage: 85,700

1997 FORD F25. THIS WAS THE SECOND SPARK PLUG TO BLOW OUT OF HEAD. FIRST REPAIR COST $450.00, THIS TIME IT COST ME MY TRUCK, 2 CAMERAS, GPS, LAPTOP COMPUTER AND SEVERAL OTHER ITEMS AS THE TRUCK COUGHT ON FIRE WHEN SPARK PLUG HIT FUEL INECTION RAIL AN STARTED A FUEL FIRE THAT BURNT THE TRUCK TO GROUND. TOTAL LOSS. BURNED MY HANDS TRYING TO SAVE ITEMS IN CAB. HAD A FIRE EXTINGUISHER, BUT HIGH PRESSURE FUEL LINES SPRAYED FIRE TO FAST. MY GIRL FRIEND, HER DOG, AND I HAD 30 SECONDS TO GET OUT. IN 2 MINUTES THE CAB WAS ENGULFED IN FLAMES. I WILL BE DISMANTLING THIS ENGINE AS I AM A MECHANIC AND MACHINIST AND PLAN TO PROVE THERE WERE NOT ENOUGH THREADS SECURING SPARK PLUGS IN THEE ALUMIN UM HEADS. THERE WERE STANDARDS OUTLINED FOR MACHINING THREADS.*AK

Mileage: 27,000

DT*: THE CONTACT STATED WHILE PARKED AND OFF, THE VEHICLE CAUGHT ON FIRE. THERE WERE NO WARNINGS PRIOR TO THE INCIDENT. THE INSURANCE AGENCY COULD NOT FIND THE CAUSE OF THE FIRE.

Mileage: 139,000

ATTEMPTING TO PASS ON A TWO LINE HIGHWAY WHEN SPARK PLUG BLEW OUT OF ENGINE. VEHICLE IS A 1997 FORD F250 4WD 80K MILES. REPAIRS INVOLVE REMOVING HEAD. COST IS $2800. VEHICLE WORTHLESS SINCE DON'T KNOW WHEN ANOTHER PLUG WILL BLOW! *JB

Mileage: 80,000

WHILE DRIVING, THE SEAT RECLINED WHICH LEFT THE DRIVER LAYING COMPLETELY DOWN. *JB THE SEAT BASE ASSEMBLY HAD BROKEN ON THE DRIVER'S SIDE FRONT SEAT. *SC THE TIE RODS HAD TO BE REPLACED. THE CONSUMER WAS UNABLE TO SHIFT GEARS, BECAUSE THE SHIFTER BOLTS HAD BROKE LOOSE FROM THE DASH MOUNTS, THE HEAD GASKETS FAILED AND THE CHECK ENGINE LIGHT NEVER ILLUMINATED. THE HUB/AXLE SEALS WERE REPLACED. *JB

Mileage: 55,000

WHILE DRIVING ALONG A SPARK PLUG WAS BLOWN OUT OF THE CYLINDER WITH THE INSUING LOUD BANGING SCARING THE DRIVER AND ALMOST CAUSING AN ACCIDENT. FORD DEALER RETHREADED SPARK PLUG HOLE AND REPLACED SPARK PLUG.

Mileage: 100,000

I OWN A 1997 FORD F250 TRUCK. ON THE BELOW LISTED DATE, WHILE DRIVING AT 0430 HRS IN THE MORNING ON A TWO LANE ROADWAY, THE THIRD SPARK PLUG ON THE PASSENGER SIDE BLEW OUT OF THE CYLINDER HEAD. I LOOKED UP INFORMATION ON INTERNET AND FOUND THAT THIS PROBLEM HAS BEEN OCCURRING WITHOUT WARNING OR FAULT OF THE DRIVERS/OWNERS FOR A NUMBER OF YEARS. THIS JUST HAPPENED TODAY AND I HAVE NOT CONTACTED ANY REPAIR SERVICE YET. IT IS OBVIOUS THAT THIS IS A PROBLEM AND FORD HAS NOT RECOGNIZED THE DESIGN FAULT. I WAS LUCKY I WAS ABLE TO GET OFF THE ROAD SAFELY DUE TO THE LACK OF ENGINE POWER FROM THIS PROBLEM. MY COMPLAINT IS THAT THE FORD MOTOR COMPANY HAS KNOWN ABOUT THIS SAFETY ISSUE FOR SEVERAL YEARS AND DONE NOTHING TO NOTIFY OWNERS OF THE POTENTIAL DANGEROUS SITUATION NOT TO MENTION UNWARRANTED COST TO VEHICLE OWNERS THAT COULD POSSIBLY PREVENT THIS IF IT WAS KNOWN. IT IS PERTANANT THAT SOMEONE OR SOME ORGANIZATION WITH STANDING AND POWER DEAL WITH THE FORD MOTOR COMPANY ON THIS ISSUE. THANKS FOR YOUR TIME. *JB

Mileage: 113,357

WHILE DRIVING, THE VEHICLE LOST STEERING AND BRAKING POWER. *AK THE ASSEMBLY THAT TIGHTENED THE BELT DRIVE AROUND THE STEEL SHAFT ABOUT ONE INCH IN DIAMETER HAD BROKEN OFF AT THE TIME WHERE THE TRUCK HAD NO BRAKES OR STEERING. *SCC *JB

Mileage: 53,000

THE RADIATOR HAS BEEN REPLACED 5 TIME DUE TO LEAKAGE. THE HEATER CORE HAS BEEN REPLACED TWICE DUE TO LEAKAGE. *TS *NLM

THE BRAKE PEDAL HAD TO BE PUMPED IN ORDER TO GET THE VEHICLE TO STOP. THE FRONT AND REAR ROTORS HAVE BEEN REPLACED 5 TIMES. THE PARKING BRAKE CABLE FAILED AND WAS REPLACED. THE RADIATOR FAILED 3 TIMES AND THE HEATER CORE FAILED. *TS *NLM

Mileage: 103,000

NATURAL GAS VEHICLE. CLAMP IN THE ENGINE WAS RUBBING ONTO FLEXIBLE HOSE THAT WAS HOOKED TO FUEL INJECTORS, CAUSING A HOLE IN FLEXIBLE HOSE, AND EMITTING NATURAL GAS. DEALER AND MANUFACTURER HAVE BEEN NOTIFIED.*AK

NATURAL GAS VEHICLE. CLAMP IN ENGINE WAS RUBBING ONTO FLEXIBLE HOSE THAT WAS HOOKED TO FUEL INJECTORS ,CAUSING A HOLE IN FLEXIBLE HOSE, EMITTING NATURAL GAS. THE DEALER AND MANUFACTURER HAVE BEEN NOTIFIED.*AK

NATURAL GAS VEHICLE. CLAMP IN ENGINE WAS RUBBING ONTO THE FLEXIBLE HOSE THAT WAS HOOKED TO FUEL INJECTORS, CAUSING A HOLE IN FLEXIBLE HOSE, EMITTING NATURAL GAS. THE DEALER AND MANUFACTURER HAVE BEEN NOTIFIED.*AK

STRONG ODOR OF DIESEL WAS IN VEHICLE. DIESEL WAS FLOATING AROUND IN ENGINE. DIESEL HAND WAS GOING DOWN. *AK

THE VEHICLE STALLS OUT AND DIES WITHOUT WARNING. THE DEALER HAS BEEN CONTACTED.

EXHAUST SYSTEM IS LOCATED IN THE FRONT OF REAR WHEELS IS CAUSING DISCOLORATION OF WHEELS AND MELTING OF TIRES. *AK

ENGINE FAILED DUE TO OVERHEAD CAM PULLEY CATALATIC CONVERTERS BEING TOTALLY BLOCKED. YH

A CATALYTIC CONVERTOR WAS PUT ON A DIESEL TRUCK. THIS CAUSED A BACK PRESSURE TO OCCUR. A HOLE WAS CREATED IN BOTTOM OF TURBO. CARBON MONOXIDE WAS ESCAPING THROUGH HEATER VENT, CAUSING A HAZARDOUS PROBLEM FOR DRIVER, WHO BECAME NAUSEOUS & HAD A HEADACHE. MANUFACTURER KNOWS ABOUT PROBLEM, BUT IS NOT DOING ANYTHING. *AK

ENGINE OIL SEALS (GASKETS) FAILED. *YC

OXYGEN SENSOR FAILED. YH

THE EXHAUST PIPE HEAT SHIELD WAS IN CONTACT WITH THE METAL TRANSMISSION FLUID TUBE FROM THE TRANSMISSION TO THE RADIATOR. OVER A PERIOD OF TIME THE SHIELD WORE A SMALL HOLE IN THE TUBE, RESULTING IN A PINHOLE, WHICH CAUSED THE TRANSMISSION FLUID TO BE RELEASED UNDER PRESSURE DIRECTLY ONTO THE EXHAUST PIPE.

CONSUMERS VEHICLE WILL NOT PASS FUTURE VEHICLE INSPECTIONS BECAUSE EXHAUST PIPE EXITS ON THE SIDE (DESIGN).

FRONT END MISALIGNMENT CAUSING VEHICLE TO VIBRATE AND PREMATURE WEAR OF TIRES. IN ADDITION, BELT TENSIONER ROLLER MAKES NOISE WHEN VEHICLE IS STARTED, AND POPPING NOISE FROM CAB WHEN DRIVING OVER UNEVEN SURFACES DUE TO CAB MOUNTING BOLTS TO FRAME BEING LOOSE. *AK

UPON ACTIVATION OF THE BRAKES DURING TRAILOR HAULING(5TH WHEEL), THE EXHAUST DEVELOPED A LEAK IN THE DOWN LINE DIRECTLY AFTER THE TURBO.

WHILE DRIVING UNDER WET OR SNOWY ROAD CONDITIONS THE ENGINE GOES IDLE ONCE TAKING FOOT OFF THE GAS PEDAL. COMSUMER ALSO STATED THAT HAS LOSS OF CONTROL OF THE VEHICLE ONCE TRYING AND PUTTING ON THE BRAKES. CONSUMER CONTACTED THE DEALER AND WAS TOLD THAT'S HOW THE ENGINE WAS BUILT INTO THE FUEL COMPUTER. *AK