1998 MITSUBISHI MONTERO Engine And Engine Cooling Problems

TL*THE CONTACT OWNS A 1996 MITSUBISHI MONTERO. WHILE DRIVING 40 MPH,THE POWER STEERING FAILED. THE MECHANIC STATED THAT THE FRONT CRANK SHAFT PULLEY BOLT DETACHED AND CAUSED THE PULLEY TO WOBBLE. THIS FAILURE WAS ENCOMPASSED IN RECALL # 00V311000. THE DEALER STATED THAT THIS VEHICLE WAS EXCLUDED FROM THE RECALL. HOWEVER, THE CONTACT STRONGLY BELIEVED OTHERWISE. THE CURRENT AND FAILURE MILEAGE WERE 94,000.*AK

Mileage: 94,000

CRANKSHAFT PULLEY BROKE OFF. LOST BELTS, LOST POWER STEERING AND ALTERNATOR POWER . REPAIR SHOP SAYS ENGINE MUST BE REPLACED. *NM

CRANKSHAFT BOLT BROKE, CAUSING TIMING BELT PULLEY/SPROCKET TO FALL OFF. THIS IS AN INTERFERENCE ENGINE AND COULD HAD CAUSED SERIOUS DAMAGE. THERE HAS BEEN A RECALL FOR THE MONTERO 3.0 ENGINE FOR SAME PROBLEM..WHY NOT THE 3.5? INTEND TO CONTACT THE CORPORATION COMMISSION. VERY POOR DESIGN.*AK

EVERYTIME VEHICLE REACHES HIGHWAY SPEEDS, ABOUT 55MPH AND UP, VEHICLE WILL END UP STALLING. HAS CONTACTED DEALER, AND THE DEALER IS NOT WILLING TO DO ANYTHING.*AK *SLC

WAS PULLING OUT OFF PARKING LOT AND CRANKSHAFT PULLEY BOLT BROKE OR SHEARED OFF. HAD NO STEERING CONTROL AT 10MPH. JUST MANAGED TO DRIVE VEHICLE TO DEALERSHIP. MECHANIC INDICATED THAT BOLT COULD NOT BE REMOVED FROM CRANKSHAFT. ENTIRE CRANKSHAFT WAS TO BE REPLACED. *AK

ENGINE STALLS REPEATED TIMES AT LOW RPM'S

OCCASIONALLY WHEN MAKING A COMPLETE STOP AND ATTEMPTING TO ACCELERATE ENGINE CUTS OFF OR SLOWS DOWN WHEN ON HIGHWAY. CONTACTED DEALER AND MANUFACTURER. *AK

WHENEVER BRAKES ARE APPLIED, VEHICLE WOULD SLIDE OR SKID. INTERMITTENT PROBLEM. TOOK TO DEALER & INFORMED BRAKES ARE STICKING. WOULD HAVE ODORS/FUMES COMING INSIDE VEHICLE. ALSO, SOME SQUEAKING COMING FROM FRONT END. *AK

METAL FRAGMENTS FOUND IN ENGINE. YH

METAL FRAGMENTS FOUND IN CATALYTIC CONVERTER. YH