2016 TRIUMPH THRUXTON Problems & Recalls

the front brakes are inconsistent when engaged. the first squeeze of the brakes are spongy and almost completely squeeze down and then subsequent braking with completely clamp in 1”. The problem does not go away even after bleeding the brakes. This has occurred since ownership of over 1 year. I on...

The wire harness has torn under ignition. The traction control stops working, needles bounce, and at times will not start. The wire pulls when the handlebars are turned to the right. I brought it to Moto primo to have it fixed. There was a recall for this issue and they want to charge me over ...

Brakes feel spongy or grinding at times. The grip on the front brakes is not good.

The front brake requires a first 'pump' to become effective. On subsequent application the brakes work as expected. After a short time I need to 'pump' the brake again (when first applying the brakes I can almost pull the lever to the grip). This is a known problem on many owner forums. Due to the s...

Very time I push the front breaks, it feel spongy. First push the leveler goes almost all way down. It becomes more firm once you push it two or three time more, however, it vanishes after that. I took it to the dealer but they said that the breaks are working good. I have also changed the break fl...

Front brake lever has an issue wherein it is soft and requires multiple pulls or deploys to full engage resulting in both inconsistent and unsafe operation. It has been ongoing and apparently widespread with other owners and not something repair shops have been able to localize or remedy.

I have had this motorcycle since new in 2016 and have put 20,000 miles on it. It has for most of its life had a problem with the brembo front brakes where they do not fully engage until you pump the brake lever twice. I had taken it to the dealer multiple times while under warranty and had the bra...

The front brake lever first pull has always been soft, since the motorcycle was new. The second pull is firm and as one would expect. I brought the motorcycle to the dealer where I purchased it and had them inspect the brakes and perform a bleed operation, which I had to pay for. The technician ...

WHEN USING THE FRONT BRAKE, I HAVE TO PRESS THE LEVER IN ONCE, THEN PRESS IT A SECOND TIME TO EXPERIENCE ITS PROPER BRAKING POTENTIAL. THIS HAS BEEN AN ONGOING ISSUE SINCE OWNING THE BIKE. I'VE NOTICED HOW JERKY THE BRAKE WOULD REACT. VERY "SQUISHY" WHEN PRESSING THE BRAKE LEVER FIRST PUMP, THEN REA...

Mileage: 2

THE FIRST SQUEEZE OF THE FRONT BRAKE LEVER IS SOFT AND MUSHY. WHEN RELEASED AND SQUEEZED AGAIN, THE LEVER FIRMS UP AND HAS LESS TRAVEL. THE FRONT BRAKE IS INCONSISTENT AND THUS DANGEROUS. THIS IS A CONSTANT PROBLEM IN ALL RIDING SITUATIONS.

Mileage: 800

THE BRAKES DO NOT HAVE PRESSURE ON THE FIRST PULL. THE PRESSURE IS BUILT BY PUMPING THE BRAKE LEVER BUT WILL THEN LOSE PRESSURE AGAIN WITHIN 15 MINUTES. IN THE EVENT OF AN EMERGENCY THE BRAKES COULD TAKE TOO LONG TO ENGAGE. THIS IS A COMMON PROBLEM ON ALL 2016-2019 TRIUMPH THRUXTON 1200 R MOTORCYCLE...

Mileage: 500

MY 2016 TRIUMPH THRUXTON R HAS ALWAYS HAD ISSUES WITH THE FRONT BRAKE. SINCE PURCHASING THE MOTORCYCLE I HAVE NOTICED THAT WHILE RIDING IT AND COMING TO A STOP USING THE FRONT BRAKE IT DOES NOT STOP AS EFFECTIVELY AS IT SHOULD. UPON GRABBING THE FRONT BRAKE AND SQUEEZING THE LEVER THE BRAKE IS SLOW ...

Mileage: 2,800

OPERATION OF THE BRAKES IS INCONSISTENT AND UNSAFE. ON FIRST APPLICATION, IT FEELS LIKE THERE IS NO PRESSURE IN THE SYSTEM SO THE BRAKE LEVER HAS TO BE SQUEEZED ALMOST COMPLETELY BACK TO THE HANDLEBAR BEFORE THE BRAKES APPLY. ON SUBSEQUENT APPLICATIONS IMMEDIATELY AFTERWARDS, THE SYSTEM FEELS PRES...

Mileage: 4,000

BRAKES ARE SOFT AT FIRST PULL. SECOND HARDENS. THEY SEEM VERY MUSHY AND UNSAFE MOST OF THE TIME.

Mileage: 6,000

I HAVE HAD 3 SIDE STAND SPRINGS FAIL DURING THIS CALENDAR YEAR 2020, IN LESS THAN 3,000 TOTAL MILES. 2 OF THE FAILED SPRINGS HAVE BEEN UPGRADED PARTS FROM A TRIUMPH INTERNAL SAFETY BULLETIN REPLACEMENT. THIS LAST SPRING FAILED 900 MILES AFTER IT WAS INSTALLED ONLY A MONTH AND A HALF AGO. ALL INSTALL...

Mileage: 14,100

THE FRONT BRAKE NEEDS TO BE "PUMPED UP" BY PRESSING AT LEAST TWICE BEFORE THE FULL POWER OF BRAKING IS APPLIED WHILE THE BIKE IS IN MOTION OR STOPPED. THIS HAS BEEN ADDRESSED BY THE SELLING DEALER AT LEAST ON THREE SEPARATE OCCASIONS WITHOUT ANY CHANGE IN PROBLEM

Mileage: 900

THE FRONT BRAKES SINCE THE BEGINNING HAVE FELT SPONGY AND I HAD A FEW CLOSE CALLS WHEN I HAD TO APPLY THE BRAKES HARD, THE MOTORCYCLE STILL KEPT GOING I HAVE TO DOUBLE PUMP TO HAVE THEM ACTUALLY WORK PROPERLY.

Mileage: 2,950

SOFT/SPONGY FRONT BRAKES WHILE RIDING.

Mileage: 10,200

THE FRONT BRAKES HAVE A VERY SPONGY FEEL AND REQUIRE MULTIPLE PULLS OR 'PRIMER PULLS' FOR THE FRONT BRAKES TO ENGAGE CORRECTLY. IN EMERGENCY BRAKE SITUATIONS, I DO NOT GET FULL BRAKING POWER OUT OF THE FRONT BRAKES WHEN THE LEVER IS PULLED IN QUICKLY. THE LEVER GOES ALL THE WAY BACK TO THE HANDLEBAR...

Mileage: 4,000

THE INSTRUMENT CLUSTER THAT DISPLAYS THE SPEED AND RPMS IS DIMLY LIT BECAUSE OF OPAQUE PAINT USED ON BACK OF BOARD CONTAINING THE NUMBERS. FOR RIDING AT NIGHT THE NUMBERS ARE TOO DIM TO READ DRIVING SPEED OR ENGINE SPEED.

NEW MOTORCYCLE AND FIRST NIGHT OUT WITH IT. INSTRUMENT PANEL AT NIGHT IS NOT LEGIBLE. THE LIGHTING ON THE INSTRUMENT CLUSTER (SPEEDOMETER AND TACHOMETER) IS TOO DIM TO BE ABLE TO READ THE NUMBERS MAKING IT IMPOSIBLE TO DETERMINE SPEED AND RPMS.

Mileage: 600